How to Use the Spirit Level

2026-09-07 17:26:43

Check before use

Inspect the level body and vials. Confirm that there is no damage or liquid leakage. Make sure the bubble can move freely inside the vial.

Place the level on the measured surface

Put the spirit level flat against the target surface. Keep full contact between the bottom of the level and the workpiece. Do not tilt or lift either end.

Read the bubble position

Observe the air bubble in the vial.

For horizontal measurement: When the bubble sits exactly in the middle of the two marking lines, the surface is horizontal.

For vertical measurement: When the bubble is centered, the surface is perfectly vertical.

Adjust the workpiece

If the bubble deviates from the center, adjust the object slowly until the bubble aligns with the middle mark.

Double verification

Rotate the spirit level 180° and re-measure the same spot. If the bubble position remains consistent, your reading is accurate.

After-use care

Clean dust and dirt off the level. Avoid dropping, impact or bending it. Store in a dry place to protect measuring precision.

You may also like?

Custom Manufacturing Solutions

OEM branding or full ODM product development — your design, our expertise.

Confirm